供应陶瓷纤维油石磨头

Easy to use with a hand grinder.
Ideal for the point processing of cross-hole deburring.

适合配合手持研磨机使用
是对交叉孔精细毛刺进行点处理的理想工具

• The tool head is made of Alumina Fiber abrasive stone. Cutting edges are exposed over the entire surface.
• Efficient removal of fine burrs where the base thickness is 0.2 mm or less after machining.
• Ideal for point processing of cross-hole fine deburring.
• Flexible shaft allows soft contact with the workpiece.
• Can also be used in a machining center, NC lathe, robot, etc.
•  
• 磨头由氧化铝纤维油石制成，磨刃布满整个表面
• 有效去除机加工后厚度小于0.2mm的精细毛刺
• 是对交叉孔精细毛刺进行点处理的理想工具
• 弹性连杆可使纤维油石磨头柔性接触工件
• 自我锐化功能提供超强持久的磨削力
• 同样适用于加工中心、数控车床、机械手等

The “Meister Finish” is an abrasive stone made of XEBEC Alumina Fibers which have the ideal crystal structure for grinding.
Shaped into spherical ball and columnar cylinder configurations, the stone surface has a multitude of fiber cutting edges providing superior grinding force and performance.
The self-sharpening action of the cutting edge on the Alumina Fiber rod tips provides superior grinding performance.
Continuous cutting edges provide stable and continuous grinding performance.

• Removal of fine burrs generated around cross-holes where the base thickness is 0.2mm or less.
  (Point processing removes only fine cross-hole burrs; no secondary burrs generated.)
• This tool also can be used not only with a machining center but also with a hand grinder for manual deburring.
•  
• 去除交叉孔周围的小于0.2mm的精细毛刺
• 不仅适用于加工中心，同样可配合手持研磨机手动去除毛刺

1. Over 20 times longer life than with an elastic grindstone.
   Over 10 times longer life than with a mounted vitrified wheel.
2. Superior edges and far fewer secondary burrs than with an electro-deposited diamond bar or a mounted vitrified wheel.
3. Point processing with no damage to peripheral area.
4. Soft contact. Suitable for automation. Also easy-to-use with hand grinder.

■Comparison of deburring finish of cross-hole burrs generated in ø3.5mm drill processing

1. Choose a head that is slightly larger than the bore diameter in secondary processing.
   (This is good for both longer tool life and better fitting.)
2. Choose the coarsest one (gray color; equivalent to #220) for efficient deburring
   (Choose orange (equivalent to #400) or blue (equivalent to #800) for superior edge quality and surface roughness.)
3. Operate at approximately 80% of the maximum RPM for each tool size.
   (Do not exceed maximum RPM.)
4. First insert the head while rotating into the primary processing hole. And then touch the head slightly onto the burry area around secondary processing hole by the flexible shaft.
   ※Do not exceed? the maximum cutting load; 5N i.e.500gf. (bending displacement of 2mm)
   
5. If the bore diameter in primary processing is small compered of secondary processing the hole becomes oval.
   So in order to obtain a uniform deburring process, slightly jiggle the head in the axial direction and rotate the tool in both the forward and reverse directions until the head fits the secondary processing hole.